Wht ar the reason for low voltage on consumer side?
- 6 Answers
- 7666 Views
- I also Faced
- E-Mail Answers
Answer Posted / austin kpoto
The technical malfunctions and reason are many here are few
1. One possible cause should be main conductor load phsae
are over loader or cabe to consumer not the recommended
size.
2. In properely load balancing to pahses
3. Faults AVR output
4. loose conductor from main breaker box to consumer
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
What should be the voltage between Neutral and Ground in secondary side of the step down transformer (230 V to 110 V) with no load condition?
hii this is ranjith from hyd... i want to know what type of questions they ask in interview...and hw the interview will go..? what subjects thay ask specially for electrical engg students?
to hook up ten 50 amp rv pedastels at a lenth of 600 feet from the service what size will my service need to be and the size of wire will I have to run to each pedastel in series??????
What is the lockout relay
What type of fittings and electrical accessories can be install in radiation area ?
Why derivative controller is not used in control systems?
What is the formula to calculate distribution transformer De-rating on iron losses basis
transformer spections :: input voltage 0-110-230v; output volage 0-10-12-14v; amp=3A using CRNO CORE, capcaity=50VA primary turns = ? ; secondry turns =?
Differentiate between ideal and non ideal current sources?
help me with the question that might be ask on the interview for technical position
what is the difference between droop mode and ischnorous mode in thermal powerplant?
How can I calculate the Mega watts required to run a plant having many electric motors and other electrical components.
If we impress a dc voltage of 230 V on an unloaded 230 V, 50 Hz transformer it wi A give high secondary voltage B burn out C give secondary voltage as per K D none of these
Why squirrel cage motor can only use with low starting loads ?
Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example?
