Interested to Buy Any Domain ? << Click Here >> for more details...
what will be happen if we apply D.C supply to the
transformer
- 14 Answers
- 23250 Views
- CCBPL, I also Faced
- E-Mail Answers
Answer Posted / mkumar
if you apply dc current in tarnsformer no change will occur
because mutual induction does not takes place on the other
hand your transformer will definetly get burn due to over
heating of windings.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
What size cable (based on voltage drop) is required to supply a 40 A three phase boiler if the wiring system is 75V single insulated cables installed in non-metallic rigid conduit 56m from the main switchboard? Voltage drop in the consumer's mains is 8V.
importance of reactive power management
what is the calculation formula for motor starting torque,running torque, running torque.
Why do power lines not short out when they fall into water?
I'm looking for a softcopy manual set for a Credence ASL- 3000. Anyone know where I can get it?
how to select the automotive wire size by mathematical calculation. for xenon headlamp with ballast. the ballast given data voltage 10-17v,current permenant 6amp, run up phase is 15amp, peak at swicth on max 400micro sec is 40amp.the sum of cable resistance is 150mohm.please provide referenc document if any for relating the peak at switch on current,time & wire wire size
Hi Friend I am used multimeter to measure the voltage between R Phase(SS1) to R Phase(SS2). In SS1 is connected with UPS loads. But I am getting voltage between these 2 R Phases. Please give some idea friend
write a program that prints prime numbers from 1-20 in digonal form
why capacitive load is not used in routine life????any reason is there ??????
What will happen if i replace a inductive proximity switch with photo sensor in a machine?
In between UPS out going changer over switch and ups raising main input, both side cable gland producing heat but the cable doesn't get heat,Why?
what is a reactive power? what is the relation with power factor?
Air refrigeration cycle works on the
before transformer oil dielectric strenght tests are taken the oil should be allowed to settle to remove option 1 air bubbles 2 gasses 3 contamination 4 water
what is a speed of rotor when we give supply to stator of 50hz and as well as rotor of 60hz of an induction motor?????
