Answer Posted / hitesh
PLC having its own/single controller but in DCS there are
more than one controller for each section. in case one
controller fails other section will run but its not
applicable in case of PLC
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
PLEASE PROVIDE SAMPLES OF CHEVRON SKILL TESTS
why we should maintain neutral earth voltage below 1V while calibration? why cant it be 1.2V or 2V
components of control circuit belongs to control valve
Basically iam Instruemntation Engineer, but Iam interested in Instruments design engineering, so plz guide, is there any course, training or Softwres to become Instrument design engineer??.
What is standard of DCS panel design?and what is step of DCS panel design?wiring and type of connector(screw or DB connector)
please tel me the calibration of pneumatic controler.
Displace type LT to be calibrated in workshop, wt. 40, dia- 60 mm, density- 0.8kg/cm3.
Draw a complete P&ID of a flow suction tank indicating all control & protection equipment. Indicate all its inlets and outlets. Explain the controls for this system
what is your eligibility criteria for freashers?
how to calculate the total flow in square root
In turbine what does term CDP, NI, NH, HSSOC means.
why we use impulse line of flow transmitter at 45 deg. angle both side of orifice plate.
What is cut off relay? And why use in PLC and DCS?
How to calibrate smoke Dectector
how to do dynolab wind speed sensor loop test, how to simulate value,i have simulate mA 4-20mA but not responding in DCS faceplate, please kindly advice me any one.
