can we use 220 volt 15 w a.c. lamp on 220 volt d.c.
- 11 Answers
- 19339 Views
- Philips, I also Faced
- E-Mail Answers
Answer Posted / dhiren
yes we can give 220v to ac lamp because the relation of ac &
dc in term of resistive load in heating.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
what is the use of current transformer in power transformer secondary side.?its connectyed in WTI
how to calculte capacitor range for single phase induction motors??pls tel
Merits & Demarits of Oil circuit & Air circuit breakers ?
Difference between control junction box (cjb) and power junction box(pjb)?
What is a copper loss or i2r loss pc?
What is cut-off rate?
How would you relate your key competencies to this position?
if we have a industrial load of 400 kilowatts with 415 volt AC then how much total harmonic distortion (thd%) should be acceptable for steady power system.
How to Calculate The Neutral Earth flat design calculation for the Synchronised generator (Gen 1-650Kva, Gen 2-725Kva
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT-SWITCH BOARD,MLDB,ACB,BUSBAR,ETC,......?
A 50Hz,4-pole,3-phase,star-connected synchronous motor has a synchronous reactance of 12ohmsper phase and negligible armature resistances.the excitation is such as to give an open-circuit voltage of 13.2kilovolt.the motor is connected to 115kilovolt, 50hertz supplying. what maximum load can be the motor torque,line current and power factor?
application s to shunt coil
sir,in our plant we r using SATEC PM172E power reading meeters in HT panel side it is monitoring the MB data smart viewer(sever).but last one week we did not get readings inthe server only available in meeter.tell me how communicate meter and server. and also what steps we take for checking.
What is the principal of motor?
How to calculate the sag on transmission Lines.
