i have 2 motor of same rating. on no load condition one
motor take 1.6A but other motor is taking 4.8A. what is the
reason of this. please explain with proof.
- 8 Answers
- 8430 Views
- Ambuja, UltraTech, I also Faced
- E-Mail Answers
Answer Posted / sakthivel
first you are check the bearing and terminal board and all
so check starter conduct knob and verify the electrical
parameter and all check pump and so impellerside
| Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
If there are two transformer having rating of 2.5mva, 6.6kv/440v(satr-star),and the load is 600kw then what is better to maintain less losses in transformer having both transformer in parellel or only single transformer connected to load? Please give calculated answer
DG cranking voltage?
if we have a industrial load of 400 kilowatts with 415 volt AC then how much total harmonic distortion (thd%) should be acceptable for steady power system.
what is doubling factor in making current of a breaker?
I have c license but I don't know eligibility of Max Kilo Volts under the electrical licensing board.
Is it possible to use a S1 duty class motor for crane application (S4)? If not, why?
I have 4 DG set with 1500KVA rating. system breakers are 11KV & alternator are 415 Volts. Between alternator & breaker one stepup transformer used. i want to Know what is max. resistance for body earthing & 415 & 11KV V Neuteal earthing. my fault current is 14 times for 2 sec.
where can i get vijaya electricals limited in hyderabad interview auestions can u give me the website address plz
how will we calculate the copper wire load..
Explain about p.t?
why the making current is more than then the breaking current and if its true then its about a controling circuit or breaker power contact points
Why it is necessary to isolate fire fighting when you are taking shutdown for lv board.
how to extend relay operating timing in 24V dc relay card (without using Timer )
Is there possible to Test Transformer for Overfluxing Capability. Or is there any firm who does Overfluxing Test on Transformer?
What is the difference between indoor and outdoor transformer
