Answer Posted / pranab
current is always flow from higher (+) to lower (-) potential.
| Is This Answer Correct ? | 1 Yes | 3 No |
Post New Answer View All Answers
what is transformor oil gread
Why is the air gap between the pole pieces and the armature kept very small?
Why insulation level follows this order? transformer < bus bar < circuit breaker & Isolator < transmission line.
What is the rating factor for copper cable ( Specific value according to the type of laying ) & the voltage drop?
What is the feedback in the control system?
What is the Good Earth resistance value of G.I & Cu. Chemical Earthing & Normal Pipe Earthing?
What are the differences between single phase and three phase?
any one guide me to reduce the power factor of diesel Generator from 0.97 Leg to 0.8 Leg.with out any change in my load.
what happend to DC shunt motor if its field winding insulation becomes slightly weak? will that motor can run on full load or not explain in detail. thanks
what ispositive, negative, zero sequence impedence?
Hello everyone, somebody knows what is a "surplice power" ? The hole phrase is: "This rating is appropriate for a generator set paralleled with an infinite bus e.g. a national electrical supply network or grid where the generator set is run at 100% load, 24 hours a day, 365 days a year and any surplice power is exported into the grid" Thanks in advance.
I want to make street light with solar system ... What may I do for procedure and how much of estimation for each material ... If any one knows guide me and inform this id : aravindd7@gmail.com
what do u understand from filter factor of reactor?
what is high - pot test. what's its use?????
what is the role of transistor in Circuit?