i have 2 motor of same rating. on no load condition one
motor take 1.6A but other motor is taking 4.8A. what is the
reason of this. please explain with proof.
- 8 Answers
- 8429 Views
- Ambuja, UltraTech, I also Faced
- E-Mail Answers
Answer Posted / virendra
Friend, if it is 3 ph then pls check the all 3ph are ok. If motor facing single phasing then this might happen
| Is This Answer Correct ? | 5 Yes | 5 No |
Post New Answer View All Answers
What will be advantage if we put some load in neutral of grounded star transformer & loadshortcircuit current,rated current of cable & MCB with example?
What are the types of class b amplifier?
difference between crane drive and line drive.
why we use circuit breakers for switching instead of normal switching device?
why impedance relay is used for medium transmission line protection
mostly the questions were from machines... d.c. machines, transformer, synchronous and induction all theory paper........ few from power system... but the level of paper was easy.....
Is it required to do earthing in 2nd shop if earthed armoured cable is laid from 1st shop ?
design a LV scheme for a 15 storied building?
in Telecom DC system-why positive +ve is made earthed.and - ve is fed to load.
While testing LA mast,What are the parameter limits ?
how generator load test is conducted?what are the steps?
Why in ESP Positive earthed
how to ctrl motor by use of ac or dc drive.plz explain evdintly
Why saturation region slowly shifted in the left side?
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
