what does happen if generator frequency fall in running
condition & what should require immediately
- 4 Answers
- 5290 Views
- I also Faced
- E-Mail Answers
Answer Posted / mahi&junu
there are two methods. Either we can decrease the load connected or we can increase the excitation
| Is This Answer Correct ? | 5 Yes | 3 No |
Post New Answer View All Answers
3Cx240 & 3Cx300 sqmm Al. cable from lv side. What is the calculation for this cable??
What is inverse definite minimum time lag relay? Where is it use?
What is the difference between electronic regulator and ordinary electrical rheostat regulator for fans?
What are the operation carried out in thermal power station?
why h parameter are called as hybrid parameter?
how 650 volts creates? where is use?
HOW TO CALLICULATE RESITENCE,REACTANCE AND IMPEDENCE VOLTGE OF TRANSFORMER 13.33 KVA 144/240 VOLTS 93/56 A WITH FORMULA
condition Autotrip facia come on control panel of electrical transmission line?
if the motor rated speed is 950rpm. how to change the above rated speed? is it possible?
why it is so called as xlpe(cross linked poly ethyline) cable?
what is the difference between torque induced and torque load?compare them with respect to dc motor?
what is the constructional difference between a power transformer and potentian transformer?
SUTIABLE FOR ohm's law super conductor
how to calulate short circuit current for the following: 1.cable connecting 11KV of 22KV/11KV transformer to 11Kv of 11KV/415V transformer 2.what cable size should i use.
a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circuit whose highest fault level is 6.6 MVA. Determine the required minimum breaking capacity in kA. (Note: Covert 3-phase power in terms of kA to find answer.) b)Using the below, determine the required minimum making capacity in kA as a “peak value”. Rate breaking capacity (Icn) ka: Icn<= 1.5 Factor = 1.41 1.5
