what is the input of conductivity sensor and meter during
the calibration time and what is the output?
- 2 Answers
- 4646 Views
- I also Faced
- E-Mail Answers
Answer Posted / amsal
as sachin wrote 4-20mA
but it is only output of coductivity xmtr.
during calibration of conductivity xmtr its I/P is
resistance (according to its range) which is given by
resistance box.
for example Range is 0- 10 uSIMENS
display------ I/P ---------------------- O/P
0 uSIMENS.= maximum R means infinity = 4mA
2.5 uSIMENS.= 750 Ohms = 8mA
5.0 uSIMENS.= 500 Ohms = 12mA
7.5 uSIMENS.= 250 Ohms = 16mA
10 uSIMENS.= 0 Ohms = 20mA
it is for example only but in practical there is non linear
i/p resistance which will be required to get o/p according
to range
and O/P is 4-20mAs which is shown in the unit of uSIMENS.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
What do you know about gail?
How to control flow variations in magnetic flow maters..... When i will provide proper earthing?
what is the criteria to decide conductor size of a cable ?
i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....
What should be the main consideration while starting the Rotating compressor when we dont know the cut in and the cut off pressure setting of the pressure switch
What are the type of bonnets in the control valves?
draw the block diagram of a level transmitter ?
Sir, I am working as a Instrument Engineer in Grasim Industries. Can any body provide question answer for interview purpose
What is the start up procedure of desalter
What is defferent betwen ESP &PCP PUMP .HOW IT IS WORK?
typical loop drawing of a simple feedback control comprising of one transmitter and one control
Area classification, Equipments, Gas groups, temperature classification, Ingress protection, Fire Extinguishers.
Sir, I want junior executive, Instrumentation question papaer for IOCL, Plz send to arabinda.ghosh83@gmail.com
What is cut off relay? And why use in PLC and DCS?
what is piezoelectric transducer?give an example in power plant n state its principle?
