Answer Posted / padmaja
The x'mer rating is in kva because as the iron losses in
x'mer is depends on voltage i.e. as per o.c. test carried
out on x'mer & copper losses is depends on current i.e. as
per s.c. test carried out on transformer.
so depending on the losses reflects voltage & current unit.
hence the rating is explained in KVA to give a detail how
much amount of power it can transfer.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
How I calculate the ELCB for circuit breakers?
How to select the earthing transformer,for DELTA TO DELTA TRANSFORMER OR ALTERNATOR SIDE.Pls post your answers and calculation.
What is difference between SMC supportg and Glass Fibre Reinforced Plastic Support.
Why does the speed regulating system adopting I controller have no steady-state error? In this single closed-loop speed regulating system, when the input of the I controller Un=0, what is the output voltage of the regulator? What factors do the output voltage depend on?
Is it true that in the 3 phase transformer, the limbs of the core are at 45 dgrees to each other. if true, why?
how line turns ratio changes in 3 phase with change in connection
Terminal blocks is used for segregate the connections... There is any principle for terminal block..?
why we change the direction of winding in rotor ?how we make the north and south pole?
What is the test block protection relay if any body know plz explained
How can we design a HVAC Plant room which includes AHU,FCU,Chillers,Cooling towers, Pumps etc & how will they work? any Drawing if possible?
Electrical Engineering
solar energy light efficiency & disadvantages?
How to dimensioning SDCCH, LAPD and CS7 signaling on GSM?
During FEED, you will have all the information with regards to cable. How will you calculate the MTO for MV and LV Cables? what are your considerations?
suri transmission
