Interested to Buy Any Domain ? << Click Here >> for more details...
I am facing one problem in my layer 2 switch I don’t know
the problem is on switch side or client side. The problem is
some PC (not all) are stop participate in LAN they don’t
send or recd. Packet from switch and if I check RJ45 (with
LAN tester)from PC side the packet and 8 pin wire is working
fine and after that process of LAN tester I plug RJ 45 in PC
now PC start recd/ send packets what is the problem I don’t
understand even client side no virus found RJ45 is ok and
switch has no problem bcoz other PC is working fine Cable
(cat 5 ) is also fine bcoz I didn’t crimp again just check
in LAN tester and start working fine. Plz any one solve this
matter. And after lan tester process pc is working fine and
after 2 or 3 hour it again start same problem and again same
process lan tester I have used
- 5 Answers
- 8126 Views
- I also Faced
- E-Mail Answers
Answer Posted / shyam
Thanks Jitendera I was waiting Ur replay only. Tell me one think can STP work on layer2 switch also. In layer 3 we can check STP and block, forward port but in layer 2 can we I don’t think so. Yes u r right it may be traffic jam. But how I resolve that my that switch port is working fine there are on problem in that switch port. I have changed also. I don’t understand what the problem is. And u give me ur mail id if u have yahoo messenger id..Thanks for answer but plz find more and provide me mail id also if u can
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What is size of ipv4 mac address?
What is the simplest way to remotely configure a router?
What is the subnet? Why is it used?
Explain what is route poisoning?
How is private ip different from public ip?
In which protocol you manually enable route summarization?
What is the virtual path?
Which mode we can't skip when we come back from interface mode?
What is the purpose of data link layer?
Tell me which protocol called rapid protocol?
What are the different memories that are used in a cisco router?
Which updates called incremental updates?
What is point-to-point protocol in ccna?
Suppose there are 3 pc's pc1 pc2 and pc3 all are connected with each other pc 1 is able to ping pc2 and pc3 but pc2 and pc 3 not able to ping pc 1 then what is an issue troubleshoot it?
Which type of routing you did in ccna?
