with the help of drive can we run the 50hz motor on
100hz,what will be its effect.
Answer Posted / vaibhav
yes we can drive the 50Hz motor on 100Hz by using variable frequency . and as we know that synchronous speed =120*f/p.
as frequency increase motor speed also increase. and also if frequency increase motor size also can be decrease in design if want to decrease
Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
The loads are connected with phase and ground then why current flow as the loads ?
Why the magneti fields are not passes from southpole to north pole
Explain cmrr?
How to calculate earth fault current for 6.6 KV , 50 HZ , 756 Amps , 3000 RPM , 0.8 PF generator
How to calculate impedance volt in Transformer?
Power Factor Correction Panel (Manual & Automatic)
Usually in the L & T make MCC feeders' power circuit,we have BMR after the MAIN CONTACTOR.,can we interchange their position, keeping the control logic same???
what is difference between speed mode and torque mode in motor?? explain in simple words please.
how we findout a ignater is faulty or not?
Define coil span?
What is knee point voltage of transformer?
A commercial Building is designed with 14th floor levels with indoor substation of three phase transformer with rated capacity of 1000 Kva.The transformer delivered 65% of its rated capacity at 0.67 power factor lagging.Because of low power factor, the power customer was penalized and certain cost was charged accordingly based on every point percentage lower than 85%.This situation may repeatedly happen on the succeding energy bills of power customer.The power customer is desired to improve its historical power factor of 0.67 lagging and no further penalty be impose by the local power company on the next bill. Q: Identify the appropriate solution you want to offer to Client?.Justify SCIENTIFICALLY and MATHEMATICALLY the principles behind the solution.
What do you mean by Stimulastion Test in Diesel Genarator / Why & when it's conducted ?
should %impedance be high or low in a power transformer? if so why?
What is an automatic controller?