why the rating of transformer in only KVA not in others?
- 7 Answers
- 7094 Views
- I also Faced
- E-Mail Answers
Answer Posted / elango
the manufacturer does not know what type of load will be
used by user(it may be resistive ,capacitive , or
inductive) so it is all dependent on power factor. so only
it is rated in VA or KVA
| Is This Answer Correct ? | 5 Yes | 7 No |
Post New Answer View All Answers
what will happen when the dc supply is given to the capacitor?
what is control supply rating of a machine
In case of HV test on medium voltage cables, BS is asking for 4 U0 where as IEC is asking for 3.5 U0. Can any one advise me how this 3.5 times or 4 times U0 is derived?
Explain the functioning of diode?
Why electrical power generation and transmission done in 3 phase system not more than 3 phase ?
how to design step down 12 V, 1mA small transformer from 220 V AC? Because according to VI relation and power transfer it results bulky...
Explain the laying procedure and laying depth of submarine/subsea power cable for 220/400KV system? Also available cable diameter?
Is a direct shorth ciruit on a branch MCCB in a Low Voltage Switchboard a correct means of tesing the performance for discrimination?
Is any AC drive(VFD) had a feature of DC injection braking? if available please mention the detail. i.e drive can supply braking torque when the motor in idle state.
one conductor length is L.and i am strech uniformly this conductor and made length is 2L.so resistance of this strech conductor is R=4R..but i want to know about area of stech conductor hows it become a/2..
Which cable is use for rtcc control panel
What is principle of Floroscent tube 36watt.
how you configure motorvision relay (L&T make)from DCS
What is a Phase shift meter? Where can I get one?
what is an unbalance in acircuit? in a three phase 3wire circuit how an unbalance will come? in a three phase four wire system how an un balance is coming?
