Answer Posted / gautam
Bootp protocol normally use it in dhcp protocol, it is
configured manully in order to give ip add or there relvent
host.
Rarp is a work just oppostie of Arp. Rarp stand for reverse
address resolution protocol. baiscaly rarp used to find out
your own ip add or mac add of computer so that you can
communicate appropritely with other computer knowing u r
mac or ip address.
| Is This Answer Correct ? | 4 Yes | 7 No |
Post New Answer View All Answers
How do I find my servers ip address?
What is the equivalent layer or layers of the tcp/ip application layer in terms of osi reference model?
Where is tcp used?
Can two ip addresses use same port?
What is the use of predictive encoding?
What is echo in networking?
What is an ip address?
Do I need a dedicated ip?
How do you check if smtp port is open?
What protocols fall under the application layer of the tcp/ip stack?
How do you tell what ports are open on router?
What port can I use instead of 80?
How to define ip address?
What happens from the point an HTTP request is received on a TCP/IP port up until the Page fires the On_Load event?
Compare the contents of the NetSim routing table with those of a IP/RIP based router
