Answer Posted / sijish
DG normaly loads up to 80% of the full load rating,
First step.Calaculate the load in KW.
Consider the staring current of the Load.
The minimum Amps rating of the dg shoul be 4 Times the
Running current of the motor load
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
How to calulate Locked rotor amper(LRA) for compressor type motors?
what is the minimum clearance between a 11KV 150KVAR capacitor cell and series reactor.can a series reactor can be mounted in the same structure of the capacitor cells structure
How do you select the pickup value of the relay?
what are the advantages and disadvantages of speed control of 3 phase induction motor by varying frequency explain with drawing
What is formula calculation size cable wire ?
what is the working principle of a DG Set, Alternator, & exiter
In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)
May I know how much values to be set for earth fault, over current and short circuit values at 11kv side? I have 11kv van 1250amps rating. Present it's taking load 80amps?
For overhead protection we use which transformer?
sometime battery charged and then automatically charged when rectifier ON conition, is there any chances please clarify the same.
how to decide no of electrodes for 1600A LT Main incomer panel
how to fit 3 HP crompton gear motor with conveyor with the use of staring delta starter or ordinary starter?
what is the meaning of neutral displacement ???
what is vtg limit of earth and neutral at transformer side?
In parallel operation time both NGR’s close or not close if both close what will happen
