what is bushing in transfermor
- 7 Answers
- 7074 Views
- Bokaro Steel, Visa Steel, I also Faced
- E-Mail Answers
Answer Posted / sindhejs
Bushings are the insulators provided between transformer
tank(or panel) and live conductors both primary and
secondary sides of the transformer.
| Is This Answer Correct ? | 7 Yes | 2 No |
Post New Answer View All Answers
what is the safety points of vaccum circuit breaker.
in general it is observed in power stations, the tertiary winding is used in higher rating Y-Y auto transformer but not in Y-Y power transformer. is the tertiary winding is compulsory then why it is not using in power transformerÂ
what is the relation between reactive power and power factor for the what is the limit of reactive power and power factor
What difference between ref protection and differential protection ?
Write down the design procedure of commutaj.
What is gain margin?
What is the difference between a Root Locus plot and a Bode plot?
the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?
Can anyone provide with a SLD for HT panel installation for a 33KV line and distribution end has three 1.5MV transformers. Is it suitable to use OCB or VCB and also provide me the suitable rating and its connection diagram.
draw the restricted earth fault protection circuit install on power transformer and identify its parameters and draw C/C curve of it
What are the types of the glands and difference between single and double compression type of cable Glands.
how can found motors folt current ? how can disided circuit breakers caoicity and breaking capicity ?
Transformer cores are laminated in order to A simplify its construction B minimize eddy current loss C reduce cost D reduce hysterisis loss
what is meant by skew width in machines?
what is reverse power relay brief explanation and in b/w where it is connected
