Answer Posted / memon aezaz
because-iron loss depends on voltage
& cu loss depends on current and due to power factor
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
i have M.TECH interview on RF AND MICROWAVE ENGINEERING IN IIT (KHARAGPUR/ROORKEE).KINDELY TELL WHAT SUBJECTS SHOULD I READ AND WHAT ARE THE INTERVIEW QUESTIONS.
used of viscocity in petrolium
what is the difference between interface and abstract class
What is the differents between the Physics & technical Physics
what is theaverage weight of one brick?
is vertical heat exchanger has better heat transfer coefficient than horizontal heat exchanger?
why is it important to take m.e mechanical?is our l;ife make happier than other b.e courses only answer no comments
If Q is the point of ABCD rectangle where QA=3CM,QB=4CM,and QC=5cm then find the length of QD ?
Equivalent resistance of 100 homs and 200 homs resistors connected in parallel is
can i have the model papers for gate along with answers on my email id krish231191@gmail.com please???
Book for preparation of HPCL (CS/IT) .
please i need nautical science past question and answer
22. A solution of 1% (w/v) starch at pH 6.7 is digested by 15 μg of β‐amylase (mol wt 152,000). The rate of maltose (mol wt = 342) had a maximal initial velocity of 8.5 mg formed per min. The turnover number is
how to prepare for bcil bitp
in vfd why we did not give directac ac supply?
