All industrial (power plant,
sugar. Cement etc...) chimneys
are circular in shape rather
than any other shapes...
Y..?
- 9 Answers
- 17344 Views
- BPCL Bharat Petroleum, UltraTech, I also Faced
- E-Mail Answers
Answer Posted / ameet
1) Eaisy in construction
2) Less leakages
3) Circular Profile provides less resistance to air flow
| Is This Answer Correct ? | 48 Yes | 7 No |
Post New Answer View All Answers
What is the use of pneumatic system?
How much pressure on air reservoir?
2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand
What is the difference between newtonian and non-newtonian fluids?
What is the sensitive part of the liner
Which impurities form hard scale and which impurities soft scale ?
What are the factors that can affect the factor of safety selection?
Draw L.O. system in diesel engine?
sir can u plz send me Jindal Steel's mechanical engg. paper and the aptitude paper of previous year....i wud be very thankful to u.... my email id..- suraj.candid@gmail.com
Identify the parts of indicator diagram?
What is difference between HP and Torque
IF RPM OF PTO OF TRACTOR IS 540,torque at pto is 21kg/cm sq.& WE NEED IT TO 1800 RPM ,THROUGH GEAR ONLY FOR THAT WHAT WOULD BE ETHE GEAR STRUCTURE( I.E.NO TEETH OF BOTH GEAR ) IN ORDER TO GET 1800 RPM OUTPUT.
Why the work per kg of air flow in axial flow compressor is less compared to centrifugal compressor for same pressure ratio ?
WHAT IS A TR REQUIRED IF AIR FLOW 6500 CMH COIL INLET TEMP 7 - 12 DEGREE C AIR TEMP INLET - 18 DEGREE C & REQUIRED TEMP IS 12 DEGREE C
pls send me HPCL model question paper for the post of officer trainee for mechanical engg. tnk u....
