Explain RC circuit?s charging and discharging?
Answer Posted / sayeed m a
The words charging and dicharging is very important in the
case of a capacitor,we can charge or discharge a capacitor
by connecting directly to Dc source or by short
circuiting.but these to process are instataneous(very
fast),in this case we are not able to measure the charging
or discharging process(time and drop of voltage),to study
or obseve this process we can connect this capcitor in
series with a high resistnce(100 k or above ),then the time
taken to charge can be clculated with certain physics
formula and we can obseve that is an exponential function
of time,the time taken to rise its voltage by 63% of the
source voltage is called time constant,and is clculated by
the relation Toe=RC.If the capacitor is 1000 Micro F and
resistance is 180K,then the time constant will be 180 s,It
is means the circuit takes 180 s to charge up to 6.7 v if
the charging source used is 10V,similary during dicharging
it takes 180 s to decay in to 3.7 V.
Is This Answer Correct ? | 10 Yes | 2 No |
Post New Answer View All Answers
Mention any one 32 bit microcontroller and explain the same.
What is the bhe signal? Explain its significance?
What is the operating frequency of 8085?
What happens when call instruction is executed?
explain the trap input for the 8085.
If the crystal oscillator is operating at 15 MHz. What will be the PCLK output of 8284?
Explain data types used in microcontroller programming,
Describe the jae instruction with the help of an example?
Why is the address bus in the 8085 tri-stated and unidirectional?
After the following has been executed MOV BL, 8C MOV AL, 7E ADD AL, BL; what will be the contents of register AL?
Define the type of interrupts in the 8085 processor?
Describe the general purpose registers of 8085?
What are the conditions under which the eu enter into the wait mode?
What is the position of the stack pointer after the pop instruction?
Explain the 8051 microcontroller architecture?