I have raw material for making Compact-Choke for flourscent
lamp of 40 Watts. We are suppose to get 0.4 amps output at
end. but we are getting 0.42 or 0.44 amps and above. We
have done many testings in different but nothing worked out.
Please suggest me how to get the correct output.
We are using 1. core winding of 700 windings of aluminium
2. E-shape iron fillings and I-shape iron fillings to
surround the winding.
- 6 Answers
- 6544 Views
- I also Faced
- E-Mail Answers
Answer Posted / sunil
Chadra,
just hit smoothly on choke, then test it, most probably u
will get o.4amps, if u dont get required value then
increase the no.of wounds up to 718, and make voltage 230
(Fix the voltage on 230V.)then try it again I hope u will
get. All the best.
Could you please inform me that where are you getting the
raw material?
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
I HAVE A INCOMING 100A MCCB TPN 25KA, CABLE LENGHT OF 80M 70MM CABLE SIZE FROM MAIN SUBBOARD TO NEW DB.BASE ON THE FAULT LEVEL SETTING OF 45KA.I WOULD LIKE TO FIND OUT 25KA ENOUGH KA. APPRECIATE IF SOMEBODY CAN ASSIST ME WITH FORMULA FOR THIS. FRM: JEFF
What is superposition theorem?
How to calculate MCB Breaking capacity.
what is the meaning of 5% droop or 7% droop in AVR?
700KW 6.6KV slip ring induction motor to use VFD to control the speed
As an electrical engineer what are the responsibilities which i can hold in TCS?
what is the difference between neutral and earth
State ohm’s law?
how calculate the electrical load for industry and office
What is the rating of a circuit breaker needed for 300 kv load in 33KV supply line of 33/415 transformer ? Whether 800/1200 amp vaccum circuit breaker can perform for a 33 KV line in input in 415 volt in output of the transformer ?
why star point of HT motor not earthed?
What’s electric traction?
What is the basic of DTH.
11000volt DG set carnt kaise banvay
what is earth pit , how we can measured it, what earth rods reference
