Answer Posted / bhargav shankhalpara
IN BTS -48V IS USED RESION BEHIND IT IS THAT
When
interference is occur in voltages it affect only positive
pulse not in negative terminal so if we make positive
common then no interference occur And we get pure -48 volts
without any interference.
“Because 2 terminal comes out from the battery and
through red wire we ground the +ive terminal so that
possibility of noise interference will get zero....noise
occur only in the +ive terminal.....that’s why we use -ive
voltage.
“
| Is This Answer Correct ? | 14 Yes | 4 No |
Post New Answer View All Answers
Explain the full form of arfcn?
explain gsm call flow for ms to sms? And gsm call flow fro ms to roaming ms?
What is bts? What are its different?
What is difference between router and switch?
How cdma is different from gsm?
What is mean by bts?
WHY RX POWER IN MICROWAVE NOT CONSIDERED LESS THEN -30dNM?
What is what is the height of esma card?
In the early days of GSM the max TRX config was 4-4-4. Now that 6-6-6 is being used, using the signalling space for the extra required b/w, how does the signalling get managed?
What is the cost of installation of BTS at a place ? justify the value, i.e. how it will cost that much.
What is the total output power of an complete bts, in dbm and watts?
Do you know how does the traceroute work?
how noc operate?
Can I have some basic interview questions on Cramer Development, OSS, COT etc? I am expecting an interview call from the client. I have 2 years of experience in Cramer development in a Telecom Industry.
Tell me bts configuration 4+2+2?
