Answer Posted / rakesh p i
Plc stands for programmable logic controller. Its a solid
state device which works on boolean algebra.\
Dcs is distributed control system which consists of
associated plc's and remote i/o devices
| Is This Answer Correct ? | 13 Yes | 5 No |
Post New Answer View All Answers
Calibration procedure for Electro magnetic Flow meter
Why 4-20 amps is being used in instruments? Why cant we use any other range instead of 4-20 amps? Why only 4 amps is taken as lower limit and why 20 amps is taken as the higher limit?
How to calibrate an pressure gauge with yantrika test bench?
CONTROL VALVE OPERATING IN MANUAL BUT NOT IN MANUAL. WHAT SHOULD BE THE PROBLEM ?
Can any one send me IOCL instrumentation question papers.. i dont know the pattern of the questions and what to prepare can any one help me on this .. my email id is anwarnishil@gmail.com
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
what is dc moter.
Why does a pressure gauge installed on reactor, doesn't have any vent line below to release the pressure? Is it any kind of designing mistake or it actually does not require any vent line? And if it does not require any vent line below it then how we are gonna release the pressure built inside the pressure gauge?
In turbine what does term CDP, NI, NH, HSSOC means.
what is span value and zero ? and how set ?
what are procedure of sox-nox calibration
Explain working principle of lvdt?
What is the difference between uv and ir scanners? and what is the workig principle of both
How to calibrate level transmitter with use of HART?
Explain the combusion chamber
