Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / kesavan.b trichy,
In Sodium Vapour Lamp Cover we see this SON-T Lamp....
Somewhat more radiation in the blue part of the spectrum.
At low light levels it is important to have enough blue
light, in order to obtain a nice full crop growth without
elongation of the plants. However, the Agro lamp gives
less “growth light” than the Green Power lamp. At higher
light levels there will already be enough blue radiation,
so the raised level of growth light from the Green Power
lamp will give a better production. So, the Agro lamp is
best used at low light levels (2000-3000 lux) and a compact
crop growth, whereas at higher light levels (>3000 lux) the
Green Power lamp will give the best results for the
majority of crops.
| Is This Answer Correct ? | 10 Yes | 19 No |
Post New Answer View All Answers
what is the use of permanent magnet generator in exciter
how to calculate vfd o/p voltage by frequency
The slip during plugging operation is given by= A 1-s B 2+s C 1+s D 2-s
What does the letter CTNM in negative phase sequence relay means?
What are the uses of lead compensator?
what about electrical pannel.? What is meant by plc pannel.?
what is the minimum winding resistance of 30hp compressor, to run or to switch on
What is sink and source?
What is the Designing & Selection Procedure for a DG/Transormer of rated capacity?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
wat is the first thing dat is needed, 2 lay a cable in some area??
upto how many load can v connect to stabilizer which is used for tv
how ceiling fan worked?
what are the components in electrical control panel (for example: 415V, 3-ph, panel to operate utility and 3-ph DG set).
Define early construction of human being
