if u have to run a 300kw moter then what is ur choice HT or
LT switchgear & explain why?
- 3 Answers
- 7333 Views
- Aditya Birla, I also Faced
- E-Mail Answers
Answer Posted / muralidaran - itc
It depends on Application. In HT conductor sizes will be
less & also motor will be more compact since current flow
will be less, but insulation level be more.
HT will be my choice, if speed controll is not required.
LT will be my choice, if speed controll is required (VFD)
Since HT VFDs are quiet high in cost.
| Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
Why AC current leads voltage in capacitor and how?
In a 3 phase 4-wire system. For a 3.5 core cable if all loads are single phase and balanced, what will be neutral current? will it be sum of all phase currents? Or it will be zero? And if loads are unbalanced what will be neutral current?
What happens if the negative to earth voltage is greater than positive to earth voltage in the battery of substation?
why the neutral point in connnection oscillates?
What will happen if we on 200kvr capacitor bank(11kv in bus)If there is low load on transformer (1.5 mva 33/11 kv)
How to calculate the value of earth capacitance in a transmission line.
A 3-phase IM is supplied from 50 Hz system. It runs at speed of 1440 rpm and slip equal to 4 %. Calculate number of pole pairs. A 1 B 6 C 2 D 3
What are the necessary solutions needed to be carried out on a malfunctioned earthing mechanism of a VACUUM CIRCUIT BREAKER.(TAMCO)
CALCULATE THE TOTAL VOLTAGE DROP AND SELECT THE CABLE SIZE IN MM-SQARE FOR A PANEL-262KW AT 110 METER FROM THE SOURCE SUPPLY , SUPPLY VOLTAGE 240/415
what is difference between window type and wound type transformers?where we will use window type and wound type transformers?
plz send me HPCL apptitude paper.. maulik_elect@yahoo.co.in
What do you mean by dependent and independent voltage sources?
How much weight an electrical engine can pull??
I Need standard operation procedure(SOP)for 500kva Oil type transformer oil filtration & Procedure for IR value checking.
What is the formula for calculating impedance of transformers connected parallel at fault level 50KA?
