1.What is the proper definition of power system stability?
2.some times a blue spark is visible in the secondary side
of a distribution transformer at the contact position of
bushings and fuse wire,why?
Answer Posted / t.swaminathan
1.System stability is generally continuos maintenance of
power with proper voltage levels. Mainly it means the GRID
VOLTAGE CONDITION / REFERRED DOWN TO THE 11 KV LEVEL.
SYSTEM IS SAID TO BE STABLE IF PROPER VOLTAGE IS MAINTAINED
WITH RATED FREQUENCY.
IT GETS AFFECTED WHENEVER THERE IS BREAKDOWNS OF
TRANSMISSION LINES/POWER GENERATION.in which case the load
is to be met by lessor power momentarily,till the
generation picks up referred to the lower/higher frequency
due to the breakdown.
2. This is simply because the connection in the LT side of
the transformer is not proper. ( loosened ).
Is This Answer Correct ? | 2 Yes | 3 No |
Post New Answer View All Answers
Please clarify 1. Icw: rated short circuit working withstand capacity 2. Icu: Rated ultimate breaking capacity 3. Ics: Rated service short circut withstand capacity 4. other specification of ACB
how to changeover ups in this power failur time?
What is difference between slip rings and carbon burushes?
What is the basic of DTH.
If I bring a basic electric meter from the States and hook it up in Costa Rica in a development that has only one transformer for the 50 homes, will it still be accurate regarding the usage of kilowatt hours?
Why does the Solid state Rectifiers for 3-ph brake motors sometimes have 2 & sometimes 3 output terminals?
What is the working principle of MIG welding? and its out put Voltage?
WHY CBCT USE ONLY IN Y PHASE NOT OTHER PHASES
how can get electrical c licence.now i am working in spining mill , transformer capacity 2750KVA. SANCTION DEMAND 2250KVA. PLEASE ADVISE ME . MY CONTACT NO 09944226823
BSNL TTA EXAM QUESTION
in 132kv substation CRT means
what is the effect of power factor of machines in starting current
What are n circles?
what is the physical connection of a analog i/p to a analog i/p module (ab plc)and through a analog o/p module(ab plc) to a analog o/p . and how all the process control by scada
how to decide the panel size like MDB ,SMDB PANEL SIZES