how to convert transmitter milliamps output to like
temp,pressure etc.....
- 5 Answers
- 26141 Views
- I also Faced
- E-Mail Answers
Answer Posted / mastersensor80
the sensor in the transmitter sense the physical effect
(pressure/level/flow) in the transducer this effect is
converted to electrical effect where we can measure 4 -20
ma for example that on the transeducer and the sensor
part,but to answer the above question it is mainly as
answered by Nitin Patil it is merly calculation as the
forumla provided by Nitin.
| Is This Answer Correct ? | 6 Yes | 3 No |
Post New Answer View All Answers
what is the responsibility of an instrument commissioning supervisor
why we r opening HOT BYPASS valve during startup of a compressor?
please send data bank of quetions answers on analytical instrumentation.
why would you like to join our company
what is use of communication wire in multipare cable(oil and gas field), why this communication wire not used in single pair cable?
Explain plc level and its type?
Difference between ultra sonic flow meter
How we connect a instrument with ground, Give brief explanation with help of diagram?
Explain working principle of lvdt?
what is intrinscily safe system and where we use?
i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....
full process of gas turbin?
Why we are using reverse action in displacer types level transmitters on some Vessels?
why direct mounted pressure transmitters is always installed with DBB ( double bleed block) valve in process line or top of the tanks ?
why we use impulse line of flow transmitter at 45 deg. angle both side of orifice plate.
