Explain the Term in CT Name Plate – Class: 5P10
- 6 Answers
- 27289 Views
- Jindal, SRES, I also Faced
- E-Mail Answers
Answer Posted / chr
5P10 DETERMINES 5% ERROR IN MEASURING DATA FOR 10 TIMES THE
CURRENT FLOW IN THE CT.
| Is This Answer Correct ? | 37 Yes | 3 No |
Post New Answer View All Answers
what are the 4 rules to start the motor?
Dear All, I am new in construction company , my boss ask a question at time of interview , If we have 60MW generation and Single Power Transformer step-up we have. if CMR 50/60MVA , ONAN, ONAF respectively , is it sufficient or not ? for that much power to transfer,
What is vaccum currcuit breaker.define with cause and where be use it device?
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
I'm looking for a softcopy manual set for a Credence ASL- 3000. Anyone know where I can get it?
What is the difference between a verilog task and verilog function?
What is difference between safe PLC and normal PLC
What is an automatic controller?
draw vector diagram and +ve,zero sequence diagram of symmetrical three phase fault.
What is cable tray, its type, and its support?
Explain what is clipper and clamper circuits?
What are diffrent type of road taxes?
When lag/lead/lag-lead compensation is employed?
1.how many types of relays? 2.difference between ATS& STS?
what could be the RMS value and average value of a 4 phase sine wave?
