Answer Posted / bhaskar msc
flow rate is besed on the terms
ie, Turndown and Rangeability
turndown means ratio of full scale range to minimum scale
Rangeability means ratio of maximum rane to min range
thats the flow is based on the two terms
and i studied from PATRANBIES author
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
can u briefly explain aboutan aryton shunt multirange DC ammeter?
how does we calibrate a square root flow transmitter ,give an example and explain it step by step like range calculation , calibration hook up series connection , zero check , and how to apply pressure , and if not geting proportional output then what should we do ?
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
can any one explain in which term we are flow flow is it volumetric r is it mass? and y
can you send remote seal interface level transmitter calculation steps for oil water saperator.
in sulfur process what is material of impulse line we use to connect with transmitter ? and does teflon affected by sulfur?
centrifugal compressor interlock? Tell me the parameter at which compressor will trip
give some question relative instrument fitter?
how to measure draft pressure in transmitter pl. give its single line digram
what is cold loop? difference between hot and cold loop?
How it the difference between force balance system and dispalacement balance system?
Why 4-20 amps is being used in instruments? Why cant we use any other range instead of 4-20 amps? Why only 4 amps is taken as lower limit and why 20 amps is taken as the higher limit?
what is the procedure to callibrate temp controller ,pressure controller,etc. suppose a temp controller showing error 1.5 degree centigrate how can i minimize it.
Which type of diaphragm use in costic line, dm water line, natural gas line, oil line?
Sir,I am going to sit for IOCL written test exam. recently.Can anyone tell me the name of 'Objective type Question Book on Instrumentation Engineering ' which will help me. Pl. mail to bidyut_71@rediffmail.com / bidyut.saha2008@indiatimes.com / bidyut.saha09@yahoo.in
