why middle phase should used for earth fault and other
phases used for over current in overcurrent and earth fault
relay?
- 7 Answers
- 9063 Views
- ABB, ONGC, I also Faced
- E-Mail Answers
Answer Posted / vinuram
first and 3rd phases are having voltage and current
flactuation.
| Is This Answer Correct ? | 0 Yes | 7 No |
Post New Answer View All Answers
can we do the star delta connection of capacitor for 3- phase motor starter.
Explain how to determine capacitor tolerance codes?
what is upper impedance and lower impedance of a distance relay
why the field winding in dc motor is not short circuited eventhough dc supply is applied across the winding
What is the principle of HIGH SPEED DIRECT DRIVE MOTOR ?
what are the different kind of cables used for transmissions?
WHAT ARE THE DATAS REQUIRED FOR PROTECTION AND METERING AND CONTROL AND LOGIC PREPARATION,HOW TO STUDY THE PROTECTION AND METERING?
How to arrange a hous hold earthing system to keep minimum earth resistance( below 7ohms).
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
why any centrifugal blower draw more current in starting. consider id fan and fd fan?
which type of amplifiers are used in multimete?
How to select transmission line type (i.e. 11kv or 33kv) for new established industries
After completing iti in electrician, how can i get certificate of electrical supervisor? What ia requirements. For it?
Rules and standards of electrical control wiring ?
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
