what will happen to give a dc supply in transformers?
- 3 Answers
- 5446 Views
- I also Faced
- E-Mail Answers
Answer Posted / mahesh sali
dc supply given to the x'mer , there is no flux produced
into the transformer due to the absence of frequency ,
cause will be damaged of insulation of x'mer and its get
overheated
| Is This Answer Correct ? | 10 Yes | 0 No |
Post New Answer View All Answers
What is clock position of Transformer?what are the clock positions are there?and what is different of them?
What are the three major categories of error?
For the requirement of a furnace of temperature range up to 1200 oC using silicon carbide rods, What is the required rate of transformer needed (please do it with all details)?
There are Two questions about Steam Turbine Generator... What is HRSG bypass of LP, HP used for in power generation? In particualar, in the event that fault of HP bypass, there would be STG TRIP in operation but none on the LP bypass fault...what's the reason ?
How to calibrate or test an LT Air Circuit breaker 440 volts, 35 KA, 800 Amps ?
How to identify the start and end of 3phase 12 lead motor if U1, U2, etc numberings are lost or erased.
What happened when capacitor connect series in ac circuit?
How would you calculate power loss in a resistor?
in control panel, how can i measuring the distance between one bus bar to another bus bar. then now only for bus bar. in mpcb and contactor also. that means one mpcb to another mpcb how much distance? how can i calculate that.
how withstand of hi-pot test outputs of transformer wire 2.5mm
What are the two major types of control system?
Iwould like to know barc interview questions
What is open delta Xformer? It's adavntages & Use?
What is accuracy of a measurement?
What are the classifications of oscillators?
