Answer Posted / j.s. patel
MCB- Miniature circuit breaker
> Low breaking capacity i.e. 9KA only.
> Low rating capacity i.e.available up to 63A only.
> Available in fixed range.
> Available in single pole.
MCCB- Moulded case circuit breaker
> Wide breaking capacity i.e. More than 85KA
> Available in wide range i.e. up to 1200A
> Adjustable range
> Not available in single pole
> Available with adjustable GF & short ckt. protection.
| Is This Answer Correct ? | 9 Yes | 8 No |
Post New Answer View All Answers
We have Diesel generator of 200KW. fuel consumption is always same,even connected light load or full load. Is it right?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
sent to a site and asked to explain how you would like a twenty seven flour building should be supplied with lighting and sockets plus a water boiler.
solor panels arrange some angle,panel is flat fitted energy was produced or not why?
How to calculate the value of earth capacitance in a transmission line.
which type of amplifiers are used in multimete?
which of the following elements is not present in stainless steel
what is the difference between dry and wet type of 132kV terminations. which one is durable
Define what is power quality meter ?
defination of lines
What is the different types of cable & current capacity of cable
how can i use REF and diffrencial relay both in 1 CT core for transformer protection?
Dear Mr B C pal...Can you plz. put some light on principle of operation of Z-Ct in conjunction to its use with 1Cx1000Sqmm HT Cables & Directional Ground Fault / Over Voltage Relays...Regd..Parag v K 9899115632
If we are given a 10 amp cable type and asked to calculate the number of cores used and the thickness of the cable, how do we do it?? please help...urgent!! i hope the question is clear enough!!
