if the t/c o/p is 4-20mv then how plc recognize it
because we are dealing with the 4-20ma in the
plc ????????????????
- 7 Answers
- 9148 Views
- I also Faced
- E-Mail Answers
Answer Posted / guest
we will convert mV in to the ma....by connecting resistance
in parallel
| Is This Answer Correct ? | 5 Yes | 4 No |
Post New Answer View All Answers
What is the PLC configuration in Cement industry?
TEMPERATURE VARIATION FOR FREQUENTLY.
What denotes the 5/8mm in the 3300XL 5/8mm proximitor probe?
1.what is controller proportional gain 2.what is the controller intergral action time. 3.A proportional plus derivative controller that has a proportional band of 20% and a derivative action time of 0.1 minutes. Construct the shape of the output waveform for the triangular input if the input rises and falls at the rate of 4 units per minute.
Explain PID controller tuning & any one method used for it.
I want to know about DDCMIS in detail ? please explain it. Also give name of reference books in which it is explained in detail in very simple manner.
A valve in series with an orifice plate (DP transmitter), is aligned for constant pressure in the pipeline, if there is an error dx, How to align it in process.
what is SIL 1 2 3
while i check zero check for dp flow transmitter some fluctuating came (0 to 458 kg/h) what is the reason?
what is interface level and how it is calibrate?
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
How many interlocks at turbine? Plz explain briefly
all types instrumentation questions want
When doing a liquid seal on a differential flow transmitter , most of the time the sealing liquid will be heavier then the process fluid. For wich application will the sealing liquid be lighter than the process fluid if transmitter is mounted below the process line.
Why trim span ? How?
