How the earth fault relay works please explain?????????
Answer Posted / greenhat25
When a fault occurs, a current flows in th secondary winding
of th current transformer.
If th current is greater than th setting of th relay, th
electromagnet is energised and attracts th armature.
The action of th armature closes and opens th normally open
and close contacts respectively, thereby closing or opening
th trip circuit.
The shunt trip coil or UV trip coil is energised or
de-energised and th circuit breaker will trip.
Is This Answer Correct ? | 13 Yes | 6 No |
Post New Answer View All Answers
when the time of backcharging the transformer three phases only enough or three phase with neutral is must.from these which one is the best one.
how to select overload-relay for perticular motor 1.for D.O.L. starter 2. for Star-delta starter ????
how does commutator convert a.c to d.c?
What is meant by harmonic distortion?
What is the gross weight to copper ratio in slip ring induction motor of 4000 HP,6.6 kv, 372amp, 992 rpm GE motor.
why ht cable end termination don't have a gland?
how to check regenerative load in drived motor
I NEED RRB APTITUDE QUESTIONS AND MODEL PAPER,PLEASE SEND MY E-MAIL joo28_eee@yahoo.co.in
WANTCONTACT NUMBER & EMAIL/ WEBSITE TO CONTACT THE SECRETARY,MADHYA PRADESH LICENSING BOARD(ELECTRICAL),K- BLOCK,3RD FLOOR,SATPOODA BHAWAN,BHOPAL
is it possible to have dc motors on single chip
What happened when voltage will half value of current ...
What si the d/f b/w KVA & KWH, kvarh & kvar, kwh & kvar phase voltage & line voltage
How do I calculate/select Droop CT ratio for various capacity of generators?
best manufacturer for busbar for outdoor switchyard having double bus bar scheme, can any one share technical specification of busbar. 132kv voltage ?
10 tube light connect in mcb breaker.one tube light is fault.so breaker is tribe.how fault is rectified.(using 3wire phase,earth,neutral)