WHEN I AM CONNECTIN TWO ELCB IN PARALLEL.ONE ELCB
TRIPPED...HOW IT HAPPEND??
- 5 Answers
- 9125 Views
- I also Faced
- E-Mail Answers
Answer Posted / prashant
if loae is high then you connect two cb, if any one of cb
is trip then ohter cb is also trip. Due to high current.
because if any cb is trip then all current is flow through
the second cb.
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
what is the diference between the 4pole & 6pole DC Motors & what is advantage 6pole over the 4pole ?
how to determine the inrush current of a transformer
Explain Energy and Power signals?
write circuit diagram for a motor rotate in forward direction once it started and when pressed the same button it should rotate in anticlockwise.
How to do cable earhing? whether by grounding Armour to ground or by running extra G.I wire along with cable? which one is preferred mostly amoung them? If the second one is more preferable how many GI wires to be run along with cable (1 or 2)?
why we have and use 3 phase not 2 or 4 or other in power system?
how can i determine the KVA/MVA rating of transformer precisely?? is there any standard test?????
how do we calculate length of starting time and repeated starting of a direct online starter?
What the main causes of transient interruptions on Over-Head Distribution Lines?
Please brief working principle & construction of permanent magnet AC Servo motor
If a current -8+6sin6t is flowing three ammeter, one is a centre zero PMMC meter, one is true rms meter and one is moving iron meter. What are the reading of these three meter respectively?
which connection is safer series or parallel?usually which connection we prefer at home?
if you are in a software company,then why do you want to come in a core company like sail, ntpc(where lots of trouble like tension but you have a good life in a it company) ?
Where servomechanism is used?
1 “earthing” for bonding of equipment and circuits to common plant earth electrode potential, 2 “protective earthing (PE)” when this bonding is required for personal safety provisions 3 “grounding” for interference suppressing bonding of screens, sys-tems with ground level 4. low-impedance earthing ? 5.primary earthing system and secondary earthing system what is that? 6.earthing electrode or mesh net earthing electrode ? very confusing , simple but very informative help required ? i will be very very thankful to you guys.
