1KVA transformer of different frequencies of
50hz,100hz,500hz&1000hz. which one of these transformer has
big size? Give reason
- 16 Answers
- 34427 Views
- Ecil, Engineers India, MahaDiscom, I also Faced
- E-Mail Answers
Answer Posted / ganesh.m
Consider the primary of a transformer is operating at 230V,
50Hz. Consider the the secondary of the same transformer
generates 12V, 50Hz. What will happen to the secodnary
voltage, if the primary is fed with 230V,1KHZ supply?
| Is This Answer Correct ? | 5 Yes | 4 No |
Post New Answer View All Answers
what is transient enclosure vltage , very fast transients, very fast transient over voltages
what is power factor ? how we can calculate the low power factor and amount of capacitor for improve that low factor ?
Can XLPE/SWB/PVC (P3) 7C X 2.5mm2 be replaced by Can XLPE/SWB/PVC (P2) 7C X 2.5mm2??? P3 vs P2
I want to know the 'Test voltage' for Tandelta testing of 3.3 / 6.6 / 11 KV Motors. Please explain
what happen if drive input fail momentry at 48.5 HZ frequency?
What happened if C.T mount at any cable or Bus bar in wrong direction . C.T going on proper work or not . C,T direction is essential thing to properly work.
please tell me when we start motor without load in star or delta connection whose current above condition,pl write formula
What happen when neutral point connected to core balance current transformer? (Neutral point of an alternator of a 180KVA DG. Neutral point connected to CBCT means enter to the CBCT)
What happens if we connect a single phase energy meter in reverse polarity.
if 12v battery get discharged for 2 months after if we put charge it will charge again?how much time it will take to charge?
What is the role of feedback in a closed loop control system?
Where servomechanism is used?
In single phase capacitor motor, if the motor rotate reverse direction then how much power will be consumed by the motor and why?
what is the difference between ups & inverter
for 100 HP Induction motor service factor is 1.2(SF) we placed a VFD at the motor side load is balance with 0.3 Amp's Phase to Phase but at incoming of VFD load is un-balance with 10 to 20 Amp's what will be cause of load un balance
