what is impedance of transformer?
- 7 Answers
- 18969 Views
- Synergy, Vijai Electricals, I also Faced
- E-Mail Answers
Answer Posted / thowsif_emerson_csm team
The percentage impedance of a transformer is the volt drop
on full load due to the winding resistance and leakage
reactance expressed as a percentage of the rated voltage.
| Is This Answer Correct ? | 63 Yes | 8 No |
Post New Answer View All Answers
A 400 V, 50 Hz, Δ connected synchronous generator has a field reactance of 0.1 Ω and armature resistance of 0.015 Ω. At full load, the machine supplies 1200 A at 0.8 pf lagging. Under full-load conditions, the friction and windage losses are 40 KW and the core losses are 30 KW. What is the machine’s overall efficiency? Ignore any field circuit losses.
What are reasond for high wattage in single phase induction motors
what is charger supervision and control supervision?
Why efficiency of generator is higher than motor at a particular load?
The specific heats of the gas at constant pressure and constant volume are respectively 1.0 kJ/kg K and 0.72 kJ/kg K; the value of R for the gas is
a governer in an Ic engine controls the
How to measure the Harmonic Distortion of UPS ie THD?
What is the estimated total hydropower potential of india?
boiler is running in rankine cycle and deisel generator is....?
what is rocking arrangement in arc heating
1. What is differential relay? How it operates? 2.How to calculate the Short Circuit Impedance in Transformer? 3.What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works? 4. While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply? 5. What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 6. Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example? 7. Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient? 8. What should be the minimum and maximum ohmic value for earthing? 9. Why DC Currents are not used in transformer? 10. What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?
0.5,1,1.5,2.5,4.0.6.0,10,16 square mm electrical wires how much take maximum current in 50htz
my b-tech percentage is 50%. what answer will satisfy the hr ?
condition Autotrip facia come on control panel of electrical transmission line?
I am a electrical engg. diploma holder,applied for junior engineer (electrical),Kolkata RRB. Have I to attend all electrical,mechanical&civil portion in written exam.???
