How to calculate HT XLPE CABLE for 11 kv / 433 v , 1500 kva
oil type transformer system?
plz provide step by step calculation
- 15 Answers
- 124689 Views
- Engineers India, Indian Railways, Polycab, Shashwat, Sitara Energy, Sonali Bank, I also Faced
- E-Mail Answers
Answer Posted / neeraj tyagi
simple for 11kv
Amp in HT= kva*1000/ 1.732*11000
= size for 78 amp HT XLPE 3 core 95 mm2 higher side.
| Is This Answer Correct ? | 92 Yes | 51 No |
Post New Answer View All Answers
What are n circles?
In an ACB shunt trip coil and undervoltage coil operated normally( breaker open and charged). But closing coil not operating untill manually discharge and recharging. Any help.
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
Is it possible to measure correct value of earth resistance & cable insulation ristance with out disconncting earth lead & both sides of cable ends? If not, any other method to measure ER & CIR with out disconneting from the system.
ANY ONE TELL ME ABOUT generator synchronization panel panel to synchronise 3 gen of 250kva both automatic and manual. 2 gen output vol 415 3ph, 1 gen output vol 400 3ph SEND THE DETAILS DIAGRAM ON THIS EMAIL ADDRESS ayazleo@hotmail.com as soon as possilble best ragrds electrical engineer ayaz mahmood SAUDI TECH
Why field rheostat is kept in minimum position while armature rheostat at maximum position?
How To increase Knowledge Of boliler regarding To Only Electrical Field..
why transformer tank is in rectangular shape what happen when it is in step shape
please give me all the Alarm .Trip ,Safety Relays & Conditions of Diesel-generators mail me on ashokbabunhce@gmail.com
What are diffrent type of road taxes?
What are the components connected in between the power supply coming from an electric pole to HT & LT Panels in a large commercial building or how the power supply connected from Electric pole to Transformer & then to the HT & LT panels of a building? Please send me answers via mail, my id is yogiagarwal@gmail.com. If possible, please give a line diagram.
In ht capacitor ckt we are using LBS Panel it having isolator with fuse, one of HT fuse flash over, so what is reason behind this event.
How will change the frequency in distribution side?
What should be the amps for a MV fuses for transformer 630kVA 20(10)/0.4 kV
What does ampere turns shows?
