4-Why we measure the insulation resistance of main core and
frame in spite of that must be connected with ground
before energize the transformer?
- 3 Answers
- 9999 Views
- I also Faced
- E-Mail Answers
Answer Posted / sr
Before energizing the transformer we are conforming that
the insulation of the core is healthy.if it got earthed
twice there will chance of circulating current during fault
condition.
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
how to compute kAIC? with formulas...
why are distributed windings generally used in alternators?
How much dc volt applied in cathodic protection system?
can you please send me the technical questions and aptitude questions of honeywell and jindal steel electrical engg. question paper my e-mail ID is(kkesavanraj@gmail.com)
for 11KV OH system what will be typical per KM "R" "L" "C" parameter. for 33KV OH system what will be typical per KM "R" "L" "C" parameter. for 33KV UG system what will be typical per KM "R" "L" "C" parameter.
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
Does outdoor isolator loose connection cause short circuit current in that circuit? if yes then how ??
When a single pase capacitor run motor- run on 230vac and Case(1)run with 8 Mfd 250 vac.capacitor , Case( 2) run with 8 Mfd 400vac capacitor. What is difference between both case regarding power ,efficiency etc?
If we impress a dc voltage of 230 V on an unloaded 230 V, 50 Hz transformer it wi A give high secondary voltage B burn out C give secondary voltage as per K D none of these
in shunt clippers why a resistor is used in sereis with the input
Draw a SLD of HT distribution EB grid up to users Transformer?
WHY THE COLOR OF OUTDOOR TRANSFORMER IS BLUE ONLY???
why and how voltage sharing in transformer, during magnetic balance test ?
Can any one know what are the symbols at the down (below) the analog ammeter??? there are 4 symbols which are they ?????
