Interested to Buy Any Domain ? << Click Here >> for more details...
Using 11000V/433V,3 ph,50Hz,500 KVA, what is the maximum
capacity of motor in KW that can be connected and started at
a single moment? Also explain about any calculations and
formulas used in deriving the same.
- 4 Answers
- 8192 Views
- I also Faced
- E-Mail Answers
Post New Answer View All Answers
what's the requirement of Dy11d0 connection of 3 phase transformer?what's use of it?
how do you test tachos and servos
what is the effect of higher value of GD???
1.Can we use 6.6/11KV 300sq mm xlpe 3core cable for LT use (415 Volt). 2. If we use it for LT then what is the current rating
A mass of 1200g is accelerated at 200 cm/s2by a force. The value of the force required is:(a) 2.4N(b) 2400N(c) 240 kN(d) 0.24N
What is the formula for calculating the Instantaneous Short Circuit & overcurrent for any breaker
Thermal withstand capability under full short circuit conditions, in terms of number of times of occurrence of short circuit and corresponding anticipated percentage reduction in transformer life.
(In MEP services) HVAC in AC Plant room what else can we provide if the chiller is not considered?
Dear all: Recently we got a question about Interface between PMS and SAP-PM.once we got a update message from PMS.we should set the deletional flag for functional location in SAP system.Is there any FM or BAPI to use?There are only functional location create and change provided by SAP. Best regards!
how mass curve differs from hydrograph.
After synchronization with grid what is the demand value QKVAR and how we will maintain that?
In ht capacitor ckt we are using LBS Panel it having isolator with fuse, one of HT fuse flash over, so what is reason behind this event.
Why we use circular(Stepped) cross section in transformer core?
Advantages/Disadvantages of earthing of neutral bus on MSB instead of separate neutral earthing for transformer/DG sets feeding to MSB
what can be the causes of capacitor start motor having a higher current that its actual
