what is the difference between starter and control panel..?
- 4 Answers
- 17098 Views
- I also Faced
- E-Mail Answers
Answer Posted / anand kumar c
Starter is used for the protection of the motor(High
starting current problem).
Starter is a part of control panel.
And control panel will be consisting of all the protection
for motor(which is required as by the user)
| Is This Answer Correct ? | 14 Yes | 4 No |
Post New Answer View All Answers
what questions will be asked for 11/33KV licence interview APSEB hyderabad. Can any one share question and answers.
what are the usual topology of transformers at different substations in the power system and why that particular topology is choosen. what are the limitaions of that topology?
Differentiate between real and apparent power?
How we can defined theecopper cable size if we know the aluminium cable size?
what is the purpose of slope in the differential relay?why we are using two slope?but in busbar differential we are using only one slope.why?
does a DG set has low fault level as compared to that of a transformer.If yes then why.
How many types of protection relays are there based on the characteristic?
Comparision of Air break circuit breaker, SF6 Circuit breaker and vacuum circuit breaker.
This is urgent!! What is a Thyristor-based 3-ways selector switch with Zero crossing control? how does it operate and where is it mostly found in a system?
when ID fan will immediately stop through VFD what exactly cause and problem the ID fan
what are factors to be consider in electrical installation like load factor,diversity factor .....
we have 3 single phase transformers. how will we generate 6 supply from 3 phase supply input
how to calculate the no load current in transformer?
1- What is the Polarization Index number be good for 15KV 3c#500MCM electrical cable? 2- Can I use the IEEE Std 43-2000 to perfom the PI test? Thanks
hi frnds what is meant by harmonics & what is meant by third hormonics,where its will occur ?thank u
