Interested to Buy Any Domain ? << Click Here >> for more details...
why the motor running in delta connection ? it can be in star?
- 13 Answers
- 57281 Views
- NTPC, I also Faced
- E-Mail Answers
Answer Posted / a.venkatswami
motor running in delta it can be in star beacuse star
connected motor has taken voltage root three times and
current high that the cost is high threrfore motor runngin
in delta but in industres star motor connection also
working its motor rating low kw.
| Is This Answer Correct ? | 4 Yes | 8 No |
Post New Answer View All Answers
What is knee point voltage?
How are load losses and no-load losses measured at site in a DG set?
what is PID control in VFD drives?
What is excitation in case of dc motor?
What is the difference between amorphous core transformer and CRGO core transformer?.
why does make gain margin and phase margin on same plot.?
with 3 phase board on a 63 amp rcd is it ok to have 6 electrical showers 2 on each phase and what problems could happen
any body,pls tell me how to done relay coordination ? how to coordinate by TCC curve?how to read the tcc curve?
I AM FROM ELECTRICAL ENGINEERING ? I AM ASPIRING FOR "BHEL".HOW I HAVE TO PREPARE .ON WHICH TOPICS TO BE CONCENTRATE MORE.PLEASE GIVE FULL DETAILS OF WRITTEN EXAM.
what is the criterion for selecting vector group of Transformers ? i mean how to decide vector group of Generator transformer, substation trasformer and transformer at consumer end
What is the actual calculation for transformer short circuit test?.
How is efficiency of DG set calculated? At many places I found the efficiency to be mentioned in percentage. But at some other places I found kWH/ litres. I want to know how dimensionless percentage value is arrived at?
if a.c supply is given to the motor,, what happen?
can I improve the furnace power factor (10 mva transformer) by adding a capacitor bank before the transformer.Does system power factor vary a lot with the furnace PF?
Can any one give an explanation about rating factors of cable? if we are laying the cable on the air with an temp 15 degree then rating factors will be 1.15 and if we are laying the cable on the air an temp 60 degree then rating factor will be 0.76 please describe it and what is the difference between rating factor and derating factor?
