In india the power supply is always in multiple of 11,
eg.220 V, 440 V...
what is the reason?
Answer Posted / mansoor
its b/c ,the power factor of sin is 1.1
Is This Answer Correct ? | 4 Yes | 20 No |
Post New Answer View All Answers
block diagram of 2 ups system connected in hot stand by mode?
what is the meaning of 0.5ohm Resistance
How to calculate capacitor bank size at a load 800kVA.
solar inverters was not connected to the nuteral link .this nutwral possible to any other systems
How to decide cable tray size?
Describe the colour rendering properties of i) tungsten filament lamps ii) tubular fluorescent lamp
A well system is when , no. of bus bar is less or more. Tell me the concept of it.
To make a basic instrumentation amplifier, it takes A One op-amp with a certain feedback arrangement B Two op-amp and seven resistors C Three op-amps and seven capacitors D Three op-amps and seven resistors
hi can any body send me syllabus of rrb electrical section engg... and past pepar also of any board...
If we have use two power cable for incomer, that time how many use cbct for earth leakage protection? 1 or 2 if 1 way? If 2 way?
Whether should be the oil level in OCTC transfomer? It should be upto winding immersed completely or should be upto tap changer s/w? How it will affect the performance of the transformer. Rating may be 33KVA
our factory is going under construction mean time transformer 1000 kva 2 nos &load break swithch 12 kv & 4 nos 750 kva 2 nos & 380 kva 2 nos generator to be errcted.how to arrange earth pits &how to earth connect & neutral pit how to calculate in earth bit size.
What is difference between safe PLC and normal PLC
1.main parts of generator? what is used A-check,B-check,C- check? 2.what is FM200 system in data centers? 3.difference between pac,ahu?
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.