Interested to Buy Any Domain ? << Click Here >> for more details...
WHAT REASEAN USE TRANSMETER TWO WIRE & FOUR WIRE
- 5 Answers
- 12957 Views
- Kentz, I also Faced
- E-Mail Answers
Answer Posted / mail2noor.hyd
hi
transmitters 2wire, 3wire and 4 WIRE
in 2 wire transmitter POWER AND SIGNAL SAME CABLES i.e in 2
wires,
in 3 wire transmitter POWER AND SIGNAL WITH EARTHING
4 WIRE--------- 2 cables for POWER another 2 for SIGNAL
POWER (SOURCE): 24V DC
SIGNAL(O/P) : 4-20mA
| Is This Answer Correct ? | 62 Yes | 5 No |
Post New Answer View All Answers
If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?
How to calibrate Field bus transmitter? procedure ?
Lux meter is the measuring device to measure the lux level of lighting fixture. in industrial sector two types of lighting fixture is being used as street lighting purpose 1. HPSV (Sodium) and 2. HPMV (Mercury). HPMV having white light which is an combination of red, blue and yellow colour, while HPSV haivng Yellow lighting. in HPSV red & blue colour will be absent. during measurement of the lux level of HPSV and HPMV fixture. 1. Lux meter can measure the actual lux level of both fixture? 2. or it will show false reading for HPSV fixture light as it has only yellow light present. please give me answer
䑰ҕ䔈ҕ䖠ҕ䘰ҕ䛀ҕ䝐ҕ䟐ҕ䢐ҕ䥐ҕŹ
What are the maximum packet size of: a) HART b) Profibus DP c)Profibus PA d) DeviceNet e) Foundation Fieldbus
What are the charcterstics of a P&ID controller block for Governor speed raise or lower for a load sharing functionality between 4 Gas turbines in droop mode.
the 3 most common transmitter protocol being in refinery or qatar gas and aramco.
How you calibrate absolute pressure with the calibration range of 0 to 1000 0C Absolute. Please explain the procedure for calibration.
what should he know if he is an assitent engineer instrumentation in cement industries of experience of 10 - 15 year.
Draw a wheatstone bridge circuit showing supply, meter and 3 wire RTD connection
we want to control pump in let pressure and tank (for exp) our inlet line if water cam and pump will on and when our tank will full pump will off also if our inlet pressure low pump will off even tank not full.this pump i want to uses on our water supply line.
Im having problems with interfase betwen SPI v7.0 and SPPID v5.05. Previous versions of Intools shoul be fixed with SPPIDproj.ocx file. It was necessary to replace this file with one that allows the connection between different versions of SPPID. It is necessary in the current version to do the same?Thanks
In power plant to measure vibration of a turbine we install sensors. Before install this sensor we have to set gap voltage. What is meant by gap voltage and its use?
hi! i want to know about mpse exam.
How vortex sensor used for steam flow measurment can be checked on line i.e without taking out from process line.
