whats the diff b/w mpcb and mcb?weather it trips on single
phasing or not.
- 9 Answers
- 14944 Views
- Electra Power, Essar, I also Faced
- E-Mail Answers
Answer Posted / vinod
MPCB: all the bove full form are correct.
its also an breaker with inbuilt overload protection.
as per the cordination in the panel after contactor OLR is
needed to be provided.if we are using MPCB there is no need
for overload relay.
MCB: Minature circuit breaker.
this limit it is available up to certain breaking
capacity.can be used for lower breaking capacity
| Is This Answer Correct ? | 6 Yes | 2 No |
Post New Answer View All Answers
give some advantages and disadvantages of combiniing the session, presentation, and application layer in the osi model into one single application layer in the internet model
What is “pu” in electrical engineering?
why the check zone and main zone are used for Busbar Protn. scheem?
What is the Good Earth resistance value of G.I & Cu. Chemical Earthing & Normal Pipe Earthing?
I'm looking for a mnaual set for a Teradyne J750. Softcopy would be preferred but I'll take what I can get.
How to measure the Harmonic Distortion of UPS ie THD?
how to calculate the battery AH
Why we used 690V in ACS 800 drives.Why dont use standard voltage like 415v or 1.1Kv
What is the reason behind current flow(20 A) in amain earth cable of an SMDB? Is cuurent flow(45A etc) through a neutral cable acceptable?
why in the three pin plug all 3 pins are cutted ?
what will happen if OLR CT in all phases are short circuted
Explain what are inter-poles and why they are required in a dc machine.
if main CT is of ratio 50/5, and meter CT is -/5 what will be overall multiplying factor of meter.PT is 11000/110 .
If a shunt Dynamo has induced emf 100V and 0.4 ohm resistance and battery of accumulator of open circuit emf 110V and 0.5 Ohm resistance are in parallel what is common terminal potential difference?
what will be happen if earth point is being used for as a neutral point for raw power , and same will be used for ups earthing
