In industries Power factor is maintained by installing a
suitable KVAR bank, How is the PF maintained for domestic
use, where is the capacitor bank connected
Answer Posted / raj
MAIN THING THE PF IS MAINTAIN FOR INDUCTIVE LOADS . IN
DOMESTIC WE HAVING THE RESISTIVE LOADS . BUT IN WE USING
FAN MOTORS AND SINGLE PHASE MOTORS ETC WE KNOW IN EVERY
SINGLE PHASE MOTOR WE CONNECT THE CAPACITOR IN SERIES OR
PARELLEL.SO PF IS MAINTAINING.
Is This Answer Correct ? | 8 Yes | 4 No |
Post New Answer View All Answers
Why do we use center tap transformer that used with portable tools
Dear All we are having a problem in G120 BOP showing alarm A0503, F0052, F0060 we can not remove fault alarm ,Please any body help us. kowsar
What are approaches to tackle sedimentation problem of reservoir?
which types of relay used in acb and vcb?
Why line VTG = √3 phase VTG in star? How?
How does a tertiary winding filter harmonic(espcially 3rd one) from entering into load system?
how to find impedance , mutual indatnce in transmission lines
what is the meaning of 5% droop or 7% droop in AVR?
In hydel power plants, L.A's, S.C's are placed inside the control panel boards. what is the purpose? [already the total body was earthed to ground.]
Why reactors use before incoming of ac vvfd drive?
What does a Bode plot tell you?
what is meant by motor startup supervision & motor load jam protection ?
Explain how to determine capacitor tolerance codes?
In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)
how we can calculate the efficiency of a diesel generator ?