generally on the roadside v hav 11kv line which is being
step down to 440v line to line....so any1 can tell me which
type of transformer they r using whether it is star to
delta,delta to star etc...???
Answer Posted / sabale.dnyanehswar@gmail.com
generally it will be 1.1 kv/0.415kv step down star -delta
transformer.
Is This Answer Correct ? | 3 Yes | 22 No |
Post New Answer View All Answers
Motor,transformers,capacitor tubelight etc....
how to select the automotive wire size by mathematical calculation. for xenon headlamp with ballast. the ballast given data voltage 10-17v,current permenant 6amp, run up phase is 15amp, peak at swicth on max 400micro sec is 40amp.the sum of cable resistance is 150mohm.please provide referenc document if any for relating the peak at switch on current,time & wire wire size
What is the function of probe in cro?
What is the ideal position cooling fan inside the dc motor?
What is the minimum underground tank size capacity considered for firefighting purpose?
whatare the disadvantages occur,if the form factor of transmission will not be equal to 1.11
What are the no-load losses for the 11000/415V transformer with the following rated capacity? 1.1500 kVA 2. 2000 kVA 3. 2500 kVA 4. 3000 kVA
if negative of DC supply used and positive is grounded through EGB, and if ELCB used in the system then is it sense the positive volatge and get tripped is it possible?
How to find out damper winding failure for synchronous machine?
what is the difference between switchgear and circuit breakers and is there any difference between outdoor and indoor switchgear and circuit breakers , and how would you differentiate between switch yard and substation and grid station . thanks
i want to learn control schedule for 11kv panel? can any one send the detailed control schedule?
How to calibrate or test an LT Air Circuit breaker 440 volts, 35 KA, 800 Amps ?
Can XLPE/SWB/PVC (P3) 7C X 2.5mm2 be replaced by Can XLPE/SWB/PVC (P2) 7C X 2.5mm2??? P3 vs P2
where the lexical paramater will use in fron end?
What is the difference in calculating size of AC cables compared to calculating size of DC Cables? Usually DC Cables are larger than AC Cables although they have the same ampacity. Why is it?