whats the diff b/w mpcb and mcb?weather it trips on single
phasing or not.
- 9 Answers
- 14945 Views
- Electra Power, Essar, I also Faced
- E-Mail Answers
Answer Posted / ravikant sahu
MPCB : Motor Protection Circuit Breaker.It is protect from
over load,Short circuit & Single Phasing also.
MCB : Miniature Circuit Breaker give protection from over
load & short circuit Only.
| Is This Answer Correct ? | 7 Yes | 4 No |
Post New Answer View All Answers
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
What is the difference between a verilog task and a verilog function?
hello everybody. what does an abnormal stator winding impedance or dc resistance show? thanx
IF alternator SCR value will be high means what happen in alternator efficency at operating power factor of 0.8
how you taken aotitude test
Define steady state error.
Explain using drawings what is reverse PID action w.r.t PID controllers.
sir iam from electrical and electronics branch ,can i appear for the hpcl offline requirtment? if yes please mail me on vikram_raju25@yahoo.co.in
In india, according to trade theory above 5 HP motor reqired star delta starter. But we R connect 11 KV motor with 14MW in Direct to line ( With VCB starter combination) Can U Guess, How it is possible ?????
what are the tests comes under the type test, what tests comes under routine tests.
What are different types of control systems?
Brushes are placed at magnetically neutral axis,when brushes reach that point,the armature conductor gets shorted,but it can be seen that the dc supply is also shorted,wont that get damage? help me plz
Is it possible to implement Restricted Earth Fault protection for a transformer without neutral CT?
How Can You Relate Power Engineering With Electrical Engineering?
What should be current in the Primary and secondary side of 1000KVA (11KV Supply)Transformer.?
