what r the main parts of central chiller plant in Air
conditioner ? explain the function of each?
- 12 Answers
- 66768 Views
- ITC Infotech, I also Faced
- E-Mail Answers
Answer Posted / giri
If to say briefly, it has compressor for compressing the
freon,then comes condenser coils for the freon to get
cooled,then freon passes to the evaporator coils where it
absorbs the heat in the room air.then it's circulated back
to the compressor cycle continuous.chilled water is used in
the condenser to cool the freon.
| Is This Answer Correct ? | 53 Yes | 19 No |
Post New Answer View All Answers
working function importance of mdc meter
Define super node?
What is the difference between shortcircuit current, rated current of cable & MCB with example? What will be the size of cable required for 5.5 KW motor (Full load current 10 Amps approx.), Starting current with DOL is 120 Amps. Aprrox. Short circuit current with LLLG fault is 2000 Amps Approx.
how wecalculate breaking capcity of acb mcb mccb .explain with example
How can you sized or estimate the ligthning arrester current rating?
What is the meaning of floating point earthing in battery backed systems ?
how to test the turn ratio of 3 phase transformer using volt meter shoe the curcit diagram.
can any one know is sbi interview based on merit or based on roll number
It is desired to flood light the front of a building 42 meters wide and 16 meters hig.Projectors of 30 degree beam spread and 1000 watt lamps giving 20 lumen/watt are availabl.If the desired level of illumination is 75 lumen/m and show a suitable scheme.Assume the cofficient of utilization, deprecitation factor and waste light factor are 0.4, 13 and 1.2 respectively.
Please explain me about Relay curves and their sources to read ?
What is a signal flow graph?
What will be electrical cost per sqft for IT building (basebuild and fitout)and for residential township?
What is the ratio of true power to apparent power in an ac circuit?
how much excitation voltage required to generate 1mw power?
What is the practical way to calculate the cable size for known ampere load?
