HOW DO I CALCULATE OVER LOAD RELAY & CONTACTOR IN DOL
STARTER?
& in dol why it is require circuit breaker?
- 6 Answers
- 20043 Views
- DLF, I also Faced
- E-Mail Answers
Answer Posted / k.suresh
motor full load ampes & 6 time higher select OLR AND
Contactor.
| Is This Answer Correct ? | 11 Yes | 27 No |
Post New Answer View All Answers
what is the differences between microprocessor and general purpose computer
During regenerative breaking= A rotating magnetic field is reversed B slip is positive C torque is positive D slip is negative
What are your personal skills and abilities for such a Master Course and your possible preparation to undertake this course?
what is power factor ? how we can calculate the low power factor and amount of capacitor for improve that low factor ?
what is the easiest method of short circuit current calculation ? pls. derive with a mathematical example in real life application.
ho can we calculate the conductor insulation value according to their ratings like voltage,current etc.how insulation value related with voltage,current and power of amachine
what is difference between 9kv 5ka surge arrester and 9kv 10ka surge arrester.
A 400KVA transformer has 400 Hz frequency. If the frequency is changed to 50 Hz, then what will be the new KVA rating?
what is circuit recombiner and how it is different from circuit breaker
How time response of the system is divided?
How cable from Kit-Kat to main switch, from starter to motor are designed?
How relay works, reverse relay, master relay, os relay, earth fault relay and what is its setting point
Could Please Explain briefly. Why used stabilizing resistance series with High impedance bus differential protection relay.
delta motor winding resistance I take normally single winding is 2.5, which value is came delta connection ie RY ?
A 100 kVA , 400 v/250 kv testing transformer has 8% leakage reactance and resistance on 100 KVA base . A cable has to be tested at 500 kv using the above transformer as a resonant transformer at 50 hz . if the charging current of the cable at 500 kv is 0.4 A find the series inductance required . Assume 2% resistance for the inductor to be used and the connecting leads . Neglect dielectric loss of hte cable . what will be the input voltage to the transformer ?
