In a three phase transformer(delta/star connected)when i
touch one end of the bulb in any one phase and other end to
earth..will the bulb glow or not..if not why?..i'm touching
the bulb in star connected side...
- 6 Answers
- 7455 Views
- I also Faced
- E-Mail Answers
Answer Posted / jagjeet
If it is distribution transformer and having 440 line to
line voltage , definately bulb should glow because the
bulb has been connected via earth i.e. 220 volts ( Phase &
Earth)
| Is This Answer Correct ? | 18 Yes | 3 No |
Post New Answer View All Answers
Can 33kva/415v transformer be run underground? If the answer is yes why and if the answer is no why?
What are the conditions to be satisfied for parallel operation of dc generators?
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
What is Plank's Law?
where rlc series ckt used?
circuit diagram of trip circuit supervision relay
how withstand of hi-pot test outputs of transformer wire 2.5mm
what precautions to be taken while desigining a LT,HT panel. Eg-LT panel PCC panel with ACB installed. HT panel VCB panel with VCB installed. & what is main diffrence betwn IP54 & IP55 construction of panel.
can i use ups power as a raw power for another ups
plz send me the syllabus or any sample paper for engineer trainee recruitment if any,on ravinder911@yahoo.com
what are the applications of PLC?
A double circuit with dog conductor 66KV Transmission line from wind farm evacuation to feeding substation having capacity of 25MW for transmission. Can same transmission network be considered for further expansion of Power & how much in MW. If we need to expand next 10-15 MW more will there any augmentation is required in transmission network? Kindly reply asap.
Starting current of a 10 HP induction Motor is ______ time’s full load current.
What are the advantages and disadvantages of closed-loop control system?
relation between power station capacity and voltage level?
